How To Set Up Tattoo Gun

The correct length is the distance from the tip of the tube to the needle.

How to set up tattoo gun. 08022021 Holding a tattoo gun correctly is significantly crucial. Set the length of the needle. You have inspected and inserted your needle.

When all machine parts are checked and proper needles are selected you can start the tattoo gun. Youve attached the rubber bands and clipcord. You have your armature bar nipple in place making sure the eyeloop to the needle is facing your left hand.

Insert the needle bar into the tube and fit the end ring of the needle bar over the rubber grommet on the armature bar. Loop a rubber band around the tattoo gun encircling the back of the frame and the front of the needle bar to cut down on vibration and lateral movement of the needle bar. Next with the contact spring you need to set the armature bar and the tool should be set to about 2mm.

Dont put much pressure on holding the tattoo gun. 18112019 Step-by-step Tattoo Gun Setup Preparing Tattoo Needles. Welcome back BEAUTIFUL CREATURES.

Step 5 Press the foot pedal to test the machine. It is the Dragonhawk Mast tattoo pen. Once that is on set it to about a 30-degree angle.

Setting up a tattoo machine is probably easier than you might think. Now as long as the tattooing machine runs and sounds correctly you are all set to go. Connecting the Power.